Articles — University

Se calculó la eficiencia real y de Carnot de un Aparato de Eficiencia Térmica (Model TD-8564).

AKARI and Spinning Dust: A look at microwave dust emission via the Infrared Aaron C. Bell's Master's Course Thesis ABSTRACT: Rapidly spinning dust particles having a permanent electric dipole moment have been shown to be a likely carrier of the anomalous microwave emission (AME), a continuous excess of microwave flux in the 10 to 90 GHz range. Small grains, possibly polycyclic aromatic hydrocarbons (PAHs), are a leading suspect. In the absence of a definitive answer on the presence of PAHs or their role as an AME carrier, some predictions have been made as to the implications of spinning PAH emission. Due to the overlap between the CMB and the galactic foreground, this topic is requiring cosmologists to consider the ISM with more care. ISM astronomers are also needing to consider the contribution of cosmological radiation to large-scale dust investigations. We present data from AKARI/Infrared Camera (IRC) due to the effective PAH band coverage of its 9 micron survey to investigate their role within the 98 AME candidate regions identified by Planck Collaboration et al. (2014). We supplement AKARI data with the four Infrared Astronomical Satellite (IRAS) all-sky maps and complement with the Planck High Frequency Instrument (HFI) bands at 857 and 545 GHz to constrain the full dust thermal spectral energy distribution (SED). We sample the average spectral energy distributions (SEDs) all 98 regions. We utilize all 7 AKARI photometric bands, as well as the 4 IRAS bands and 2 HFI. We carry out a modified blackbody fitting, and estimate the optical depth of thermal dust at 250 micron, and compare this to AME parameters. We also show plots of each band's average intensity for all 98 regions vs. AME parameters. We find a positive trend between the optical depth and AME. In the band-by-band comparison the AKARI 9 micron intensity shows a weaker trend with AME. In general, the MIR correlates less strongly with AME than the FIR. The optical depth vs. AME trend improves slightly when looking only at significant AME regions. Scaling the IR intensities by the ISRF strength G0 does not improve the correlations. A slightly positive trend found previously among 10 AME regions vs. AME significance is revisited, using the larger sample of 98. However the trend does not hold up to the full data set. We cannot offer strong support of a spinning dust model. The results highlight the need for full dust SED modelling, and for a better understanding of the role that magnetic dipole emission from dust grains could play in producing the AME.

Description of results of fieldwork at Pocono Environmental Education Center with students from Malcolm X Shabazz High School, May 2005.

A template for muletter, a document class for the typesetting of letters at the Masaryk Univer­sity (Brno, Czech Repub­lic).

Template for honours theses

This simulation plan aims to explain and document all steps to be taken in the simulation analysis of the Fokker-100 case. This case is the scenario in which the aircraft touches the ground during landing, introducing loads on the landing gear. The landing gear consists of 2 rear gears around mid-span and one in the front. Furthermore, the pilot uses the rudder which induces a lateral force on the tail. As stated in the assignment, it is required to find the maximum normal stress and location of this in the fuselage, the maximum shear stress and its location in the fuselage, and the maximum shear flow in the frames that introduce the loads from the landing gears into the fuselage.

В данной работе решается задача моделирования поверхности открытого океана в реальном времени с использованием GPU для вычисления поля высот.

With rapid electrification of transportation , it is becoming increasingly important to have a comprehensive understanding of criteria used in motor selection.For that design and comparative evaluation of interior permanent magnet synchronous motor ,induction motor and switched reluctance motor are needed.A fast finite element analysis (FEA) modeling approach is addressed for induction motor design.Optimal turn off and turn on angles with current chopping control and angular position control are found for Switched Reluctance Motors (SRM).Noise Vibration and Harshness (NVH) analysis are done using workbench ANSYS analysis.Simulation and analytical results show that each motor topology demonstrates its own unique characteristics for Electric Vehicle / Hybrid Electric Vehicle.Each motor's highest efficiency is located at different torque-speed regions for the criteria defined.Stator geometry ,pole/slot combination and control strategy differentiate Noise Vibration and Harshness performance.

Contains the thesis template using memoir class, which is mainly based on book class but permits better control of chapter styles for example. This template is an adaptation and modification of Oscar's. Memoir is a flexible class for typesetting poetry, fiction, non-fiction and mathematical works as books, reports, articles or manuscripts. UoB guidelines: The dissertation must be printed on A4 white paper. Paper up to A3 may be used for maps, plans, diagrams and illustrative material. Pages (apart from the preliminary pages) should normally be double-sided. Memoir class loads useful packages by default (see manual).